欢迎光临上海光春动平衡机设备有限公司官网! 咨询热线:13636433206

请登陆后台添加(banner)标题

请登陆后台添加(banner)标题

请登陆后台添加(banner)标题

耳闻不如一见 车轮动平衡机的操作

* 来源 : * 作者 : admin * 发表时间 : 2017-05-17 * 浏览 : 37

汽车轮胎动平衡机在生活中很多人都见过但不是并不了解,也许还有没不曾听说过。至于轮胎动平衡机的操作步骤相信就会更很多人都不知道吧,跟着小编一起来看看吧。

Car tire dynamic balancing machine in life, many people have seen but not do not know, perhaps not heard. As for the operation of the tire dynamic balancing machine, I believe it will be a lot of people do not know it, followed by a small series to see it.
1.将轮胎动充到合适的气压,去除轮辋上的铅块,将轮胎花纹沟里的石子剔除干净,将轮辋处理干净.
1 will be charged to the appropriate tire pressure, remove the lead on the rim, the tire ditch stone removed and clean, clean the rim.
2.将轮胎动安装面朝内装上平衡轴,选择合适的椎体,用锁紧装置将轮胎锁紧,椎体一定要对准中心孔。否则可能数据不准。
2 will be installed in the face of the tire mounted on the balance shaft, select the right vertebral body, with a locking device to lock the tire, the body must be aligned with the central hole. Otherwise the data may not be allowed.
3.打开动平衡机电源,拉出尺子测量轮辋距离平衡机的距离,轮辋宽度,轮辋直径,并依次输入测量出来的数据。
3 turn on the power supply of the dynamic balance machine, pull out the ruler to measure the distance of the balance wheel, the width of the rim and the diameter of the rim.
4.按下开始按键,动平衡机开始带动轮胎旋转,测量开始,注意不要站在轮胎附近 一面发生危险
4 press the start button, the dynamic balancing machine began to drive the tire rotation, the beginning of the measurement, pay attention not to stand on the side of the tire danger
6.将轮胎旋转至动平衡机一侧位置灯全亮在全亮这一侧的轮辋最高点也就是12点的位置敲入相应克数的铅块,另一侧也是如此。
6 will lead to tire rotation balancing machine side position all lights at the highest point on the side of the rim is 12 points in the corresponding number of grams, so is the other side.
最后重复4以后步骤,直到动平衡机显示为0,5克以下即可,因为没有5克以下的铅块,动平衡机也不显示5克以下的不平衡量。
Finally, after repeated 4 steps, until the dynamic balancing machine is 0 to 5 grams, because no lead less than 5 grams, balancing machine does not show the unbalance of less than 5 grams.