欢迎光临上海光春动平衡机设备有限公司官网! 咨询热线:13636433206

请登陆后台添加(banner)标题

请登陆后台添加(banner)标题

请登陆后台添加(banner)标题

八大因素影响动平衡机做平衡校验

* 来源 : * 作者 : admin * 发表时间 : 2017-05-17 * 浏览 : 35

动平衡机是依赖转子自身的重力作用来测量静不平衡的,但是前提条件是平衡机自身要是平衡的,所以我们首先需要对平衡机做好平衡校验,而以下这些因素正是影响平衡机校验的,我们一起来了解下。

Dynamic balancing machine is dependent on its own gravity rotor to measure static unbalance, but the precondition is to balance machine itself if the balance, so we need to do first to check the balance balance machine, and these factors are influencing check balance machine, we work together to understand.
1.传动带不符要求,有明显的接缝。
1 the transmission belt does not conform to the request, has the obvious joint.
2.传感器的输出讯号不正常。
2 sensor output signal abnormal.
3.支承架上能移动的零部件处的紧固螺钉未能固紧。
3 the fastening screws on the movable parts on the support frame can not be tightened.
4.左右支承处有高低,使转子左右窜动或轴颈平面与支承处相擦。
4 around the support has a high and low, so that the rotor left and right movement or shaft neck plane and the support phase rub.
5.安装平衡机的地基不符要求,底部结合面未垫实,地脚螺栓未紧固,或放在楼面上,引起共振。
5 installation of balancing machine foundation does not meet the requirements, combined with the bottom surface without pad, the anchor bolt is not fastened, or on the floor, causing resonance.
6.支承块严重磨损或滚轮跳动增大。
6 bearing block serious wear or roller bounce increases.
7.支承处有污物,未加润滑油。
7 support with dirt, no lubricating oil.
8.动平衡机光电头未对正反光纸,光电头镜面模糊,光电头位置偏斜引起角度偏移。
8 balancing head is not opposite photoelectric light paper, photoelectric head mirror, photoelectric position deviation caused by angle.
以上这八个因素都是影响动平衡机做平衡校验的。
These eight factors are the impact of dynamic balancing machine balance check.